2 INSTALLATION
9070
9
Make sure the interconnect cable from the sensor unit is long enough
to reach the transmitter easily. The cable should terminate on terminal
block TB3 on the analog board.
9
Push the end of the cable through a gland in the left-hand side of the
transmitter case.
9
Noting that the shield drain wire terminates at Pin 10 of TB2 on the
analog board, attach the remainder of the cable end to the terminal
block TB3, following the wiring diagram shown in Fig. 2.4. You may
pull the terminal block away from the pins on the board if required
FIGURE 2.4 WIRING THE INTERCONNECT CABLE TO TRANSMITTER
Caution:
The terminal block for the sensor unit connection has eight
terminals, yet there are 12 pins on the board. Make sure that you choose the
correct eight pins for the connection: These are marked on the PCB, with a
separate silk-screened “box”.
2.5.2 WIRING OF BOARDS
Pass any remaining cables through the appropriate glands. Note that Pin 1 of
each block is nearest the top of the case. Prepare the cable ends and attach
them to the terminal blocks as follows:
Digital Board
(nearest front panel): No Terminations
8
