WALTHER PILOT PILOT SIL XXII, Руководство по эксплуатации

Страница: 16 / 38

8 Trouble shooting
Warning
Prior to any retooling the spray gun should be depressurized state, i. e. atomising air
as well as the material pressure - risk of injury.
9
Disposal of cleaning and servicing substances
Waste spraying media and waste material from cleaning and servicing must be dispo-
sed of in accordance with all applicable local and national regulations.
Warning
Observe the instructions issued by the manufacturers of the spraying and cleaning
material at all times.The improper disposal of waste material endangers the health of
human beings and animals!
10 Technical data
Net weight: 740 g
Material nozzles available: 0,5 • 0,8 • 1,0 • 1,2 • 1,5 • 2,0 mm ø
Aircaps: Round-jet aircap V1010901053
(for material-nozzle sizes 0,5-1,5 mm)
Round-jet aircap V1010901203
(for material-nozzle sizes 2,0 mm)
Pressure ranges:
Min. input air pressure 2 bar
Max. input air pressure 6 bar
Max. material pressure 2 bar
Max. operating temperature
of the Spraygun: 43°C
Noise level
(measured at approx.
1 m from the spray gun) : 83 dB(A)
Air consumption:
Right to effect technical changes reserved.
Atomising air pressure SIL XXII SIL XXIII
2 bar 90 l/min 82,5 l/min
3 bar 130 l/min 135 l/min
4 bar 170 l/min 195 l/min
5 bar 200 l/min 255 l/min
6 bar 230 l/min 345 l/min
10
9
Error Cause Troubleshooting
Gun drips/sprays
when not in use Air pressure too low
Material hose too hard
Increase air pressure to at
least 2 bar
use softer hose
Pulsating or shim-
ming
spray jet Material volume too low
Wrong air cap position
Fill in material
Adjust air cap position