Walter DIALSPEED, Руководство пользователя

Страница: 14 / 36

EN
14 DialSpeed
TM
DIALSPEED
TM
SELECTOR
Select the required speed by rotating speed selector (3). Positions 1-6
roughly equal the following no load revolutions per minute:
Pos. 1 2 3 4 5 6
6141 E 10,000 14,000 18,500 22,000 26,000 30,500
6145 E 2,500 4,000 5,500 7,000 8,000 8,700
Note amperage rating under TECHNICAL DATA.
DIALSPEED
TM
SETTINGS
Set the Dialspeed to position 4 and adjust either up or down until you
have found a speed that meets your requirements. The correct setting
will depend on:
a) Type of material being worked.
b) Abrasive accessory being used.
c) Amount of pressure being applied.
d) Surface finish required.
DYNAMAX
TM
ELECTRONICS
The built-in electronic feedback circuit continuously monitors the load
on the motor and adjusts power as required to maintain a virtually
constant speed under moderate load.
OPERATION
Please be sure to read and observe the SAFETY INSTRUCTIONS at
the beginning of this manual.
Use only accessories that are suitable for these power tools and that
meet their minimum RPM requirements.
The use of any accessories other than those recommended may be
hazardous. Inspect accessories before using. Do not use any that
may be damaged.
For maximum performance and best efficiency, apply a steady and
even pressure. Do not use excessive force. Always wear protective
equipment.