Walter 640045, Руководство по эксплуатации

Страница: 25 / 56

GB
25
IMPORTANT
This product contains a lead-acid battery.
In order to keep the battery in good condition it is important that you following these
instructions carefully:
1. Charge the battery using the plug-in charger according to the instructions below
as soon as possible after purchasing the machine.
2. Charge the battery using the plug-in charger at least once a month, regardless
of the battery status indicators, even if you do not use the product.
3. Charge the battery immediately after you use the product, each time you use the
product.
4. To prevent the risk of damage this product should be secured an in upright
position when transported in your car’s boot.
5. Failure to charge the product regularly will invalidate the warranty.
OPERATING INSTRUCTIONS
MAIN FUSE
The machine is supplied with four 32 V DC / 15 A automotive type fuses. For technical reasons
the machine is not factory fitted with a fuse. The three fuses can be found in the storage
compartment at the rear of the machine.
CAUTION! If the main fuse is missing, broken or incorrectly inserted the machine
can not be charged and the compressor, work lights and 12 V DC outputs cannot
be used.
CAUTION! All the switches on the front panel of the machine must be OFF before
you change the fuse. Never use a fuse with a rating higher than 15 A.
Proceed as follows:
- Check the fuse regularly and replace if
required.
- Insert a 15 A fuse into the slot on the front
of the machine.
- Ensure the fuse is pushed in far enough to
bridge the contacts and must be flush with
the machine’s front panel.
Remove the fuse if you do not intend to use the device for a longer period of time.
If necessary use a pair of long nose pliers to remove the fuse from the slot.
640045_Anleitung_D,GB,SLO:PRINT 14.03.2016 8:34 Uhr Seite 25