32
33
6.3 Mounting the barndoors
Mounting the barndoors is much easier if the LED light is removed from the light stand or
ceiling mount.
• Press and hold the barndoor lock clip (13)
• Put the barndoor in the three slots on the front panel of the light.
• Make sure the barndoor is right in the slots and that the barndoor is not inserted at an angle.
• Release the lock clip (13) to fix the barndoor.
• Finally, check that the barndoors are securely seated and the bandoor lock is put in place.
• The LED light is ready for use and can be mounted again on a light stand or a ceiling rail.
• To remove the barndoors, proceed in reverse order.
NOTICE
When closing the 4 light flaps, first push the collapsible light flaps together and fold them in.
Then fold in the large flaps.
7. Power supply
We strongly recommend that you use the angled power connection extension cable (25) for
the power connection of the LED light. The angled shape of the cable significantly relieves
tensile load to the power connection socket of the LED light (1). This ensures reduced wear of
the power connection socket.
• Switch the device <OFF> with the ON/OFF switch (10) on the device.
• Insert the 4-pin XLR plug of the AC power adapter into 4-pin XLR socket of the extension
cable and insert plug of it into 4-pin XLR socket on the light.
• Connect the power cable (23) to the AC power adapter (26).
• Connect the power cable (23) to the local mains power socket (AC 100 - 220 - 240 V / 50 - 60 Hz).
• Set the power ON/OFF switch (10) to <ON>.
• The device is now ready for mains power operation.
• Switch the lamp off after use.
NOTICE
Only connect the power supply unit to an earthed plug.
NOTICE
After use, disconnect the device from the local power supply by simply pulling out the mains plug.
NOTICE
Compare the local electric power supply with the connection values of the
device. Should the connection values not match, please contact
[email protected] or phone +49 (0) 821 – 455 789 804.
8. Operating and using the device
8.1 Switching the device on / off
• Connect the power supply as described in the previous section 7.
• Switch the device <ON> with the ON/OFF switch (10) on the device.
• The LED light is ready for use.
8.2 Setting brightness (dimmer function) on the device
• Switch the device on with the ON/OFF switch (10) (if not already done).
• As standard, the LED light is pre-set to dimmer function after switching on.
The <DIMMER> field does not flash.
• By pressing the multi-function button (12) <MODE> several times, you can switch between
adjusting brightness (dimmer function), color temperature adjustment (only Bi Color version)
and DMX-Channel setting.
