~ 2 ~
Please read this instruction
manual carefully before install-
ing your new system as failures
caused by incorrect installation
and operation are not cover by
the warranty.
1. Application
1.1. The TPHK series is multi-stage centrifu-
gal pump designed for industrial use,
especially for machine tools.
1.2 The pump can not be used to transfer
explosive liquids; such as gasoline,
diesel oil or similar liquids. It is suitable
to carry liquids such as water, coolant,
low viscosity or other non-corrosive
liquids.
CAUTION
This pump has been tested to water only.
2. Product Code Designation
The standard range of pumps includes
complete impeller in chamber combina-
tions. Upon request, a special length can be
supplied by fitting empty intermediate
chambers instead of standard chambers
with impellers. The pump nameplate
indicates the number of chambers and
impellers fitted to the pump.
3. Operating Limits
1. Ambient temperature :
Max. 122°F (50°C)
2. Liquid temperature range :
32°F (0°C) to 194°F (90°C)
3. Flow: 10 GPM to 75 GMP
4. Head: 20ft to 280ft
5. Operating pressure :Max. 142 psi
6. Submerged depth :Min. 2.6"
TPHK 2T
**
- 4 S
Stainless steel series
Number of Impellers
Number of Stages
Standard capacity m
3
/hr
Model name
4. Installation
The pump has hot surface on the
motor. It must be installed so
that persons cannot accidentally
come into contact the hot
surface.
4.1. Submerged Depth
To avoid dry running and damage the pump
during operation, the minimum pump
submerged depth is 65mm (2½”) as shown
in Fig 1. In addition, the bottom of the pump
suction inlet must be at least 25 mm (1”)
above the bottom of the tank.
Min. 65 mm
25 mm
Fig.1
