Wallenstein WX540, Руководство оператора

Страница: 28 / 45

Operating Instructions
WX540, WX540L
Trailer Wood Splitter
28
00187
Fig. 23 –
Ignition Switch
Under normal conditions, use the following procedure
1. Stop loading material onto the splitter bed.
2. Decrease engine speed to MIN.
3. Turn the ignition switch OFF.
6.11 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp the log by the sides not the ends when
placing in or removing logs from the splitter. This
minimizes the chance of the operator getting fingers, hands
or arm between the wedge / push block and the log.
• Any logs or debris remaining on the splitter bed should only
be removed after it is safe to do so.
00645
Fig. 24 –
Correct Log Placement—Horizontal
6.12 Splitting Wood
WARNING!
Risk of pinching or crushing hazard! The worker
loading the splitter MUST be the only one in
control of the hydraulic cylinder and splitting
wedge.
Only one worker should operate and load the
wood splitter.
W036
6.12.1 Horizontal Splitting
1. Place wood or log on the splitter.
2. Push control lever forward and hold to split wood.
3. Release the lever when the log splits or cylinder reaches full
stroke and stops.
4. Pull the lever back to retract the push block or wedge.
The detent holds the lever until the cylinder fully retracts,
allowing hands-free operation.