Wallenstein WX520, Руководство оператора

Страница: 31 / 40

WX520 / WX520L / WX520T
Log Splitter
Service and Maintenance
31
9.5 Change the Hydraulic Fluid
Change the hydraulic fluid at 100 hours of operation or
annually.
Hydraulic fluid type: Dexron® III ATF
CAUTION!
Risk of burns to exposed skin.
Hydraulic fluid gets hot during
operation, which makes hoses,
lines, and other parts hot as well.
Wait for the fluid and components to
cool before starting maintenance or
service.
The hydraulic tank drain plug is located under the machine. A
3/8" Allen (hex) wrench is required to remove it.
00208
Figure 17 –
Hydraulic Tank Drain Plug
Procedure
1. Place a drain pan of suitable capacity under the drain plug.
2. Clean the area around drain and remove the drain plug.
3. Allow the fluid to fully drain, then flush the tank.
4. Replace the plug and fill the tank with clean fluid.
5. Dispose of used fluid in an environmentally safe manner.
9.6 Change the Hydraulic Fluid Filter
Change hydraulic fluid filter at 100 hours of operation or
annually.
The filter is located on side of the hydraulic fluid tank.
CAUTION!
Risk of burns to exposed skin.
Hydraulic fluid gets hot during
operation, which makes hoses,
lines, and other parts hot as well.
Wait for the fluid and components to
cool before starting maintenance or
service.
00209
1 2
Figure 18 –
Hydraulic Filter
1. Hydraulic Filter
2. Drain Plug
Procedure
1. Place a drain pan of suitable capacity under the filter head.
2. Remove the oil filter. An oil filter wrench may be required.
3. Apply a light coat of clean oil to the seal on the new filter
and install it. Tighten by hand only.
4. Run the machine for 1–2 minutes operating the cylinder.
Check filter head for oil leaks.
5. If a leak is found, shut off the machine and correct it.
6. Check hydraulic reservoir oil level. Top up as required.
7. Dispose of spilled oil in an environmentally safe manner.