Wallenstein WX470, Руководство оператора

Страница: 23 / 36

00745
Fig. 16 –
Vertical Splitting
6.8 Wood Splitter Break-in Period
Although there are no operational restrictions on the wood
splitter when used for the first time, it is recommended that the
following mechanical items be checked:
After operating for 1–5 hours:
1. Check all nuts, bolts, and other fasteners. Tighten to their
specified torque. See page 28.
2. Check the condition of all hydraulic lines, hoses, and
fittings. Replace any that are damaged. Re-route those that
are rubbing, pinched or crimped. Tighten any fitting that is
leaking. See page 29.
3. Check and remove any entangled material.
4. Check the oil level in the skid steer hydraulic reservoir. Add
as required.
6.9 Transporting
6.9.1 Transport Safety
1. Comply with local laws governing safety and transporting
of machinery on public roads.
2. Clean all debris off the splitter. Remove any tools or other
loose items.
3. Never allow riders on the machine.
4. Be a safe and courteous driver. Always yield to oncoming
traffic in all situations, including narrow bridges,
intersections, and so on.
5. Watch for other traffic when near or crossing roadways.
6. Do not drink and drive.
7. Before transporting, perform a walk-around inspection to
ensure everything is safe.
6.9.2 Prepare for Transport
• Make sure the pivoting main frame is fully lowered to
horizontal. The lock pin in the pivoting splitter beam must
be fully engaged.
• Swing the locking latch up to engage the tab on the splitter
frame. Insert the lynch pin.
00750
Fig. 17 –
Lock Pin and Latch Engaged
• Clean all debris from the splitter that could fall off in
transport.
• Always be in compliance with all applicable local
regulations when transporting.
WX470
Skid Steer Wood Splitter
Operating Instructions
23