Wallenstein FX Series, Руководство оператора

Страница: 30 / 56

Controls
FX85, FX110, FX140
PTO Skidding Winch
30
F
S
F
S
00835
Fig. 39 –
Receiver Function and Select Buttons
3. Press the receiver Select (S) button just below the Function
Button. The relay LEDs light red.
4. On the transmitter, press and hold the up and down arrows
simultaneously. The LEDs inside the receiver then flash
three times to acknowledge the signal is being received.
5. Release the buttons on the transmitter. The relay LEDs
flash red once indicating receiver and transmitter are
now synchronized. If no transmitter is found within
approximately 10 seconds, the receiver exits to normal
operation.
5.11.7 Erasing all Transmitters from the
Receiver
In the event it is necessary to erase a transmitter from the
receiver, follow these steps:
1. Press the receiver Function (F) button. The function LED
lights red.
2. Press the receiver Select (S) button. Keep pressed at least
4 seconds. All relay LEDs light red then go off.
3. Release the receiver Select (S) button. All transmitters are
now erased from the receiver.
If the function LED flashes red, one or more transmitters are still
registered in the receiver and the above procedure needs to be
repeated.