Wallenstein CT24, Руководство оператора

Страница: 34 / 48

6. Service and Maintenance
WARNING!
Stop conveyor and disconnect power source
before performing service or maintenance
procedures.
6.1 Maintenance Safety
Always place the machine in a safe service position before
performing any service or maintenance work, storage
preparation, or hooking / unhooking. This Safe Condition
involves performing the following:
SAFE CONDITION
1. Empty the conveyor.
2. Shut off the conveyor drive by turning the flow control
off.
3. Lower the conveyor fully until it is resting on the frame
stops.
Follow good shop practices:
• Have at least two workers present when performing
maintenance on this equipment. Never work alone in case
an emergency should arise.
• Keep service area clean and dry.
• Never work under unsupported equipment.
• Use only genuine OEM replacement parts. The
manufacturer is not responsible for injuries or damage
caused by using non-approved parts or accessories.
• Make sure all safety shields and devices are re-installed
after a maintenance or service procedure is finished.
• Do not use gasoline or diesel fuel when cleaning any parts.
Use a regular cleanser.
• Use proper tools that are in good condition. Make sure the
procedure is understood before performing any service
work.
IMPORTANT! If equipped with the accessory power pack,
refer to the engine manufacturer's manual in the manual for
engine maintenance and service information.
6.2 Maintenance Schedule
Perform maintenance procedures at time shown or hour
interval, whichever comes first.
As Required
Remove any entangled material from conveyor.
Check that all fasteners are tight.
Every 50 hours or Annually
Grease conveyor drive bearings. See page 35
Every 100 hours or Annually
Check tire pressure.
See rating on tire
sidewall
Clean machine. Remove debris
and entangled material.
—
Check chain tension. Seepage 35
Grease Hand Winch. See page 36
Service and Maintenance
CT24
Trailer Firewood Conveyor
34