Wallenstein BXT72S, Руководство оператора

Страница: 55 / 76

WARNING!
Keep the end of a disconnected battery cable
away from the battery. Electricity can arc from
the battery to the end of a battery cable and
cause the battery to explode. An explosion can
cause serious injury or death from heat, impact,
and chemical hazards.
W115
• Keep all sparks and flames away from batteries. Electrolyte
fumes are explosive.
• Do not jump start a frozen battery. The battery can explode.
• Wear the appropriate gloves and protective eye wear, or a
face shield when you work with or near batteries.
• Use a battery carrier to lift the battery or put your hands on
opposite corners of the battery. Keep the battery level to
avoid spilling acid through the vents.
• Avoid contact with battery electrolyte:
• External contact : flush immediately with water.
• Eye contact : flush with water for 15 minutes. Get
medical attention and clean any spilled electrolyte
immediately.
• Disconnect the battery ground cable before servicing any
part of the electrical system. A spark or short circuit can
cause personal injury.
9.6.2 Remove the Battery
1. Disconnect the battery cable from the negative (–) battery
terminal.
2. Disconnect the battery cable from the positive (+) battery
terminal.
3. Remove the battery hold-down bracket.
4. Remove the battery from the machine.
Use a battery carrier to lift the battery or put your hands on
opposite corners of the battery. Keep the battery level to
avoid spilling battery acid through the vents.
9.6.3 Install the Battery
1. Put the battery in the machine.
2. Install the battery hold-down bracket.
Make sure that the battery cannot move.
3. Connect the positive (+) battery cable (usually red) to the
positive (+) battery terminal.
4. Connect the then negative (–) battery cable (usually black)
to the negative (–) battery terminal.
5. Apply a coat of dielectric grease or petroleum jelly to each
battery terminal.
9.6.4 Clean the Battery
When the battery cable ends are not connected to the battery
terminals, keep them away from the battery.
1. Disconnect the battery cable from the negative (–) battery
terminal.
2. Disconnect the battery cable from the positive (+) battery
terminal.
3. Apply a coat of baking soda to the battery terminals and
battery-cable ends.
4. Pour a small amount of water over the baking soda.
5. Use a wire brush to clean the battery cable ends and the
terminals.
6. Rinse the battery cable ends and terminals with clean
water.
7. Wait until all of the water evaporates or use compressed air
to remove the water. Make sure that the battery cable ends
and terminals are fully dry before connecting them.
8. Connect the positive (+) battery cable (usually red) to the
positive (+) battery terminal.
9. Connect the negative (–) battery cable (usually black) to the
negative (–) battery terminal.
10. Apply a coat of dielectric grease or petroleum jelly to each
battery terminal.
9.6.5 Charge the Battery
IMPORTANT! Do not fast charge the battery. Use a battery
charger that is between 4 A and 7.5 A. Do not use a charger
that is higher than 10 A.
Always read and obey the information that is provided with
the battery and the battery charger. For more information and
instructions, contact the battery manufacturer and battery
charger manufacturer.
1. Remove the battery from the machine.
For instructions, see
Remove the Battery on page 55 .
2. Use a battery carrier to lift the battery or put your hands on
opposite corners of the battery.
Keep the battery level to avoid spilling battery acid through
the vents.
3. Put the battery in a dry, cool place that is away from activity
and has good air flow.
4. Use a battery charger to charge the battery.
For instructions, see the battery charger manufacturer
information.
BXT72S
Wood Chipper
Service and Maintenance
55