Wallenstein BXT52S, Руководство оператора

Страница: 31 / 76

6.4.2 Electronic Fuel Management System
Operation Safety
The engine has an electronic fuel management (EFM) system
that monitors the engine speed, temperature, and battery
voltage. The EFM system cannot be adjusted.
• Do not start the engine if the battery cables are loose.
• Turn the key to the STOP position or remove the starter
switch before disconnecting, removing and/or installing the
battery.
• Do not use a battery charger to start the engine.
• Do not disconnect the battery cables while the engine is
running.
• When connecting the battery cables, first connect the
positive (+) cable and then connect the negative (-) cable
to the battery.
• When charging the battery, turn the ignition switch to the
STOP position and disconnect the negative (-) battery cable
from the battery.
• Do not spray water directly on the Electronic Control Unit.
6.4.3 Check the Engine Oil Level
IMPORTANT! For more information about engine oil, see
the engine manufacturer's manual and
Engine Oil on page
49 .
Operating the engine with a low oil level can cause engine
damage that is not covered by the warranty.
The engine must be in a level position for the
dipstick to show the oil level correctly.
Check the engine oil level before each use.
1. Park the machine on level ground.
2. Stop the machine.
For instructions, see
Stop the Machine on page 34 .
3. Remove the oil-level dipstick and clean it.
4. Fully insert the oil-level dipstick.
5. Remove the oil-level dipstick and check the oil level.
The oil level is correct when the oil is visible on the dipstick
from the end to the full (upper) mark.
6. Do one of the following:
• If the oil level is correct, continue with step 7.
• If the oil level is low, add oil until the oil level is at the full
(upper) mark. For instructions, Add Oil to the Engine on
page 32 .
7. Install the oil-level dipstick and make sure that it is tight.
02118
Figure 19 –
Engine oil level check
BXT52S
Wood Chipper
Operating Instructions
31