Safety Signs
BXS Series
3PH Self-feed Chipper
Safety
14
7. WARNING!
Refer to the operator's manual. Read
ALL operating instructions in the
manual. Learn the meaning of ALL
safety signs on the machine before
operating it!
The best safety feature is an informed
operator.
8. WARNING!
Risk of personal injury!
Stop the machine and disconnect the
PTO shaft before performing any repair
or maintenance procedure. Place the
machine in a state that makes it safe to
work on. See
9. WARNING!
Risk of personal injury. Operate chipper
at the correct PTO speed and direction.
Tractor PTO must operate at 540 or 1000
rpm, rotating in the direction of the arrow.
10. CAUTION!
Pinch point hazard.
On models where the hopper can be
raised, be aware of pinch points. Keep
hands clear to avoid injury.
3.3 Replace Damaged Safety Signs
•
Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or the factory.
•
Keep safety signs clean and legible at all times.
•
Parts replaced that had a safety decal on them must also
have the safety sign replaced.
Procedure
Installation area must be clean and dry. Make sure the surface is
free of grease or oil. Ambient temperature must be above 50 °F
(10 °C).
Determine exact position before removing the
backing paper on the decal.
1.
Peel the decal off the backing sheet.
2.
Align the decal with an edge on the machine if possible.
3.
Starting on one edge, carefully press the center of the
exposed sticky backing in place, smoothing it out as you
work from one side to the other.
4.
Use a squeegee, credit card or similar to smooth it out.
Work from one end of the decal to the other end.
Small air pockets can be pierced with a pin and smoothed out
using the piece of sign backing paper.
