BXC34 / BXC34 Bundle
Wood Chipper
Service and Maintenance
33
9. Service and Maintenance
Regular preventive maintenance can improve performance and
prolong the life of the machine. Machine maintenance is your
responsibility.
9.1 Service and Maintenance Safety
WARNING!
Before you start service or maintenance work:
• Set the machine to a safe condition.
• Wait for the machine to cool down. Engine
components and fl uids may be hot enough to
cause burns.
• Read and understand all of the service and
maintenance safety information.
W041
WARNING!
Wear the personal protective equipment (PPE)
that is required to complete the work safely.
This includes, but is not limited to a hard hat,
hearing protection, a face shield, protective
footwear, a respirator, and heavy gloves.
W101
WARNING!
When service or maintenance work is complete,
install all guards and/or shields that were
removed. Operating a machine with a guard or
shield removed can cause serious injuries and/or
machine damage.
IMPORTANT! See the engine manufacturer's manual for
maintenance and service information.
Set the machine to a safe condition before you start any
service or maintenance:
SAFE CONDITION
1.
Stop the machine.
For instructions, see
.
2.
Wait for all moving parts to stop.
3.
Disconnect the engine spark-plug wire and keep it away
from the spark plug.
•
Follow good shop practices:
-
Keep the work area clean and dry.
-
Ground electrical outlets and tools.
-
Have adequate light for good visibility.
•
Never operate an engine inside a closed building. The
exhaust fumes may cause asphyxiation.
•
Never work under equipment unless it is securely
supported with blocks.
•
Always have a minimum of two people present during
maintenance or service. Do not work alone in case an
emergency situation occurs.
•
Keep a fire extinguisher and first aid kit readily accessible at
all times.
•
Do not use gasoline or diesel fuel to clean parts. Use a
regular cleanser.
•
When replacement parts are necessary, use genuine
factory replacement parts to restore your equipment
to original specifications. The manufacturer cannot be
responsible for injuries or damages caused by use of
unapproved parts or accessories.
•
Check all of the fasteners after the work is complete.
Tighten any loose bolts, nuts, or screws.
•
Check all electrical and fuel connections to make sure
that they are secure and the machine is in a safe working
condition.
•
Use tools that are in good condition and correct for the
task. Make sure that you understand how to use the tools
before performing any service work.
