Wallenstein 2E9US111XNS091454, Руководство оператора

Страница: 59 / 72

BXTR6438
Trailer Wood Chipper
Service and Maintenance
59
6.15 Electrical System – General
IMPORTANT! When assembling or replacing wire
harnesses, apply a thin coating of silicone dielectric grease
to the harness connectors.
Clean off any corrosion or loose particles, then apply a
small amount to the surfaces of the connectors where they
meet. The grease helps to stop any possibility of future
corrosion.
Reassemble the connection. Wipe off any grease that
squeezes out.
IMPORTANT! If welding on the machine becomes
necessary, sensitive electronic components must be
removed from the machine beforehand. Welding can
produce stray voltage spikes that can damage these items.
• Disconnect and remove the P3 Display and Controller
from the machine.
• Disconnect/unhook the machine from the tow unit,
tractor, or carrier machine.
• Disconnect the machine’s battery (as equipped).
Disconnect the negative battery cable first before
disconnecting the positive battery cable.
• Place the welder ground clamp as close to the work
area as possible. Keep the welder cables away from the
control system electrical harnesses.