![background image](http://html2.mh-extra.com/html/wallas/85-dt/85-dt_operation-manual_3230568002.webp)
HEATING WITH BLOWER LID
(STOVES WITH BLOWER LID)
Once the stove is fully ignited, lower the blower lid down
until it locks and the device will begin to blow warm air
for heating.
When the PI Thermo Mode is chosen,
the orange thermostat/blower lid light
is on.
Rotate the
Temperature/Power Knob
to the
desired temperature (refer to temperature
chart on the first page) or heating power.
Switch between modes by turning the
Temperature/Power Knob
back and
forth to min - max - min.
To switch back to cooking, unlock the lid and push
it back to upward position. Make sure the stove is
in Manual Mode before cooking.
Stove does not operate correctly if it is left in
PI Thermo Mode.
In Manual Mode, the light is off.
PI Thermo Mode:
Set a target temperature (C°/F°)
Manual Mode:
Control heating power with knob
Heating on
30 s
30 s
Combustion has begun/is running
Set temperature on heater is higher than
cabin temperature - power is increasing
Set temperature on heater is lower than
cabin temperature - power is decreasing
Locked for security
The device locks itself
after two unsuccessful starts
Sun Switch has shut down the device
Cooldown/Flameout
I
Heating on in High Altitude Mode
I
Overheat
I
Reminder indicating there was a fault
after fault code flashed for 5 min
30 s
www.wallas.com
If the unit has locked itself,
the combustion light and the
heating indicator light will
flash signaling there has been
a failure that should be
investigated and resolved
prior to further use. Lights
will flash for about 5 min.
1) While the lights are still
flashing, switch the main
power off from the battery
(Pull power plug, remove the
fuse, open breakers, or in-line
switch).
2) Wait for 5 sec. and switch
the main power back on.
3) Press Heat Button (3) for
more than 3 seconds to shut
down the heater.
4) Restart the heater
normally.
UNLOCKING THE
UNIT
Reach Out to a Professional for the Following:
Glow Failure
2 s
2 s
Combustion Air Blower Fault
2 s
Main Blower Fault
2 s
2 s
I
I
I
Low voltage (usually about 15 sec
after initiating start)
I
See instructional video
to unlock
All rights reserved. Wallas-Marin reserves the right to change or improve its products and to
make changes in the content of this guide without obligation to notify any person or organization
of such changes or improvements. Go to www.wallas.com for current updates and supplemental
information concerning the use of this product.
PANEL LIGHTS
I