Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 94 / 182

94
wallaceperimetersecurity.com
Phone: 866.300.1110
USER MENU FUNCTIONS
Table 5. SmartDC Controller - User Menu Functions
Ref.
No�
User Menu Setting Options
(
Bold
= Factory
Settings)
Menu Tasks and Explanations
Associated
DC Controller
Connections
Display
1
CT 0 (OFF)
CLOSE TIMER
0 = Timer disabled
1 second to 99 seconds
Assign how many seconds before the open
gate initiates closure.
Keep the setting at 0 if a hard-wired, push-
button control device is being used.
Note:
The CLOSE TIMER display does not
appear when the HOLD TO CLOSE is set to 1.
Not applicable
(N/A)
2
HC 0 (OFF)
HOLD TO CLOSE
0 = off
1 =on
Set to 0 produces a gate closure when a
momentary signal is transmitted.
Set to 1 if a constant hold to close signal,
such as a push-button control, is being used.
A setting of 1 also deactivates the automatic
close timer and causes its menu to disappear.
You must set HC to 1 to comply with UL 325
Type D protection. Refer to “Table Notes” on
page 97 .
COM
CLOSE
3
HO 0 (OFF)
HOLD TO OPEN
0 = off
1 =on
Similar to HOLD TO CLOSE, but configures
the OPEN push-button for a constant-hold
function.
0 = Momentary open signal
1 = Constant hold OPEN push-button
required. You must set HO to 1 to comply
with UL 325 Type D protection.
Refer to “Table Notes” on page 97 .
COM
OPEN
4
AP 0 AC LOSS
UPS FAIL OPEN
0 = UPS FAIL OPEN
1 = UPS FAIL CLOSE
2 = AUTO OPEN
3 = NO CLOSE TIMER
The setting designates what action the gate
performs during an AC power loss.
Refer to “Setting AC Power Loss Gate
Function” on page 92 .
(N/A)
5
RO 0 (OFF)
RADIO OPEN CLOSE
0 = off
1 = on
Configures radio input for open only (0). If
changed to setting 1 then adds the capability
for radio input to close the gate, but only
when the gate is fully open.
COM
RADIO OPEN
USER MENU FUNCTIONS