Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 149 / 182

Alpha/Delta (Kinetic Operator) Installation and Maintenance Manual Revision 1 - MAY 2023
149
ACCESSORY CONNECTIONS
Edge sensors may be used with an edge transmitter and a receiver in order to transmit to the gate operator.
The use of retractable cord reels or curl cords is not recommended because of durability problems with
these devices in outdoor environments.
• Mount gate edge sensors to the leading edge and bottom edge of the gate so that entrapment
protection is provided in both directions of travel.
• Mount one or two edge transmitters onto the gate panel near the upper corner of the leading edge
of the gate. All edge sensors will function correctly if only one transmitter is used, but wiring multiple
edges to a single transmitter may be impractical or displeasing visually.
• Connect the edges to the terminals in the edge transmitter and set the “dip” switches of the transmitter
to match the setting in the receiver to be used. Refer to “Figure 45. EMX-IRB-MON Photo Eye Wiring”
on page 150
.
• Mount a gate edge receiver (external antenna type) in the channel of the chassis on either side of the
operator.
• Mount an external antenna onto the top of a fixed post of the fence near the operator.
• Connect the antenna into the socket on the radio receiver.
• Set the “DIP” switches in the receiver to match the same code used in the transmitter.
Test the operation of the reversing edge to make sure that it functions correctly. Advise the gate user
that they must retest this vital function weekly. If there is also to be a radio receiver for a hand-held
transmitter to operate the gate, be certain to use a two-channel commercial receiver. The edge and hand-
held transmitters must have their codes set to match the receiver or they will not function.
Accessory Connections
After programming the sensor inputs in the installer menu or during initial startup, the appropriate type
and number of sensors will need to be connected. Figure 45 shows the wiring and dip switch settings of an
EMX-IRB-MON photo eye (typical thru-beam wiring). A retroreflective photo eye will be similar and only
have wiring similar to the receiver of the thru-beam photo eye.
For UL 325 compliance, all external
entrapment protection sensors must
have N.C. sensor outputs
for
monitoring and powering purposes.