Ultimate Digital Quad Connect Muff with
Bluetooth
®
4.0
Power On:
-‐Short press the BT button to turn on the Bluetooth® feature (LED will flash every 1 second).
Power Off:
-‐Long press and hold the BT button for 3 seconds to turn off Bluetooth® device.
Pairing:
-‐Long press and hold the BT button for 1 second to enter
pairing mode after turn on (time out 60-‐seconds).
-‐Search and select advertising name: “Walker HD” to connect.
-‐Auto re-‐connect to previous last connected device during
pairing if the BT device has been paired previously.
-‐After paired, blue LED will be flashing every 10 seconds. LED
is located under the battery compartment cover.
-‐Bluetooth® device will be turned off after 60 seconds.
Answer Call:
-‐Short press the BT button to answer incoming call.
Reject Call:
-‐Long press the BT button to reject the call.
Cancel/end call:
-‐Short press the BT button to cancel/end call.
Call on hold/waiting:
-‐During phone calling, if another new call is received, double
press the BT button to switch from first call to second call.
-‐To switch back to first call short press the BT button to end
the second call and it will be switched to previous call.
Last number redial:
-‐Double press the BT button to re-‐dial the last phone number.
Audio pause/play:
-‐Short press the BT button to pause/play music.
(TOLL-‐FREE CUSTOMER SUPPORT (877) 269-‐8490)
FCC NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Shielded interference cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.
Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.
Volume Control Knob
AFT Control Knob
Battery Compartment
BT -‐ Bluetooth
®
Sync Button
Paired – Blue LED Flashes
Not Paired – LED Off
