1
6
8.1 Main Control System Control Mode
8.1.1 Control Mode Classification
There are three control modes according to the 3-position switch: Manual Mode \Position Hold Mode \ One Key
Go Home.
8.1.2 Control Mode Switch Setting(The factory setting is RTF, the default setting use "MIX" switch. please refer
"Transmitter device output" for method).
Please choose a 3-position switch as control mode switch before flight.
8.2 Code binding
Please follow the rule “Turn on transmitter first
and aircraft battery later” Turn on the radio
first, please connect the aircraft power within
10 seconds. The Code binding successfully
when the left green LED indicator flash quickly
to slowly and then light out last.
8.3 Motor unlock/lock/ Stop rotating
8.3.1 Motor unlock
8.3.2 Motor lock
Down the throttle stick to the lowest position, move the rudder stick to far right, the motors are locked when the
left green LED indicator light out. If you push the throttle up, the motors won’t rotate.
Notes: The aircraft is in Motor lock status after Code binding successfully.
8.3.3 Motors stop rotating
If you push the throttle to the lowest positon, the motors stop rotation.
8.3.4 Notes
(1) After unlock, the motors would get into lock status after 10 seconds.
(2) The factory default setting for the motors are locked after finished ID binding.
08
Basic Flight
Instruction
Left green LED
Right green LED
Once binding, push the throttle stick to the lowest position and
keep the throttle trim at the neutral position
. Then
push the rudder stick to the far left side and the Left green LED indicator turn solid Green, that means motors
are unlocking. If you push the throttle up, the motors will rotate.(Note, the motors can unlock only under manual
mode)
(1) Manual Mode
MIX Switch to“0”Position
(2) Position Hold Mode
MIX Switch to“1”Position
(3) One Key Go Home
MIX Switch to“2”Position
8.3.1 Motor unlock
8.3.2 Motor lock
Rudder stick
Throttle stick Throttle\Rudder stick
ELEV
stick
Rudder stick Throttle stick
Throttle\Rudder stick
ELEV stick
Mode1(Throttle stick on the right)
Mode2(Throttle stick on the left)
Mode1(Throttle stick on the right)
Mode2(Throttle stick on the left)
