Assembly Instructions
26
CHECK HYDROSTATIC TRANSMISSION OIL
LEVEL
Refer to
LUBRICATION
for
Checking Hydrostatic
Transmission Fluid Level
in
Maintenance Instruc
tions.
CHECK FUNCTIONS OF INSTRUMENT PAN-
EL AND WARNING HORN
Turn the ignition key to the
RUN
position. Voltmeter,
Oil Pressure Light, and Warning Horn should all op-
erate, indicating normal function.
CHECK FUNCTION OF SAFETY INTERLOCK
SWITCHES
Refer to
Operating Instructions
to check for proper
operation of safety switches, both during engine
starting and with the operator leaving the seat with
tractor moving forward or with the mower blades en-
gaged.
CHECK TIRE PRESSURE
Deck Caster Wheel = 20 PSI (137 kPa)
Drive =
15 PSI (103 kPa)
Rear =
20 PSI (137 kPa)
CHECK AND CLEAN GRASS BUILDUP UN
-
DERNEATH MOWER DECK (and inside GHS
blower, if equipped)
Refer to
CLEANING
the
GHS Blower
in
Mainte
nance Instructions
for blower cleaning information.
DANGER
Never operate cutter blades with deck in
raised position because it is hazardous.
The tilt-up deck can be secured in the raised posi-
tion by unlocking the deck lock levers on each side
of the carrier frame and inserting the deck hook into
the tilt-up latch on the tractor body. Before operating
the tractor, make sure to re-engage the deck lock
levers after lowering the deck to the normal operat-
ing position.
CAUTION
Do not operate machine with deck tilt-up
pivot joint unlocked.
Tilt-Up
Hook
Tilt-Up
Latch
Tilt-Up Hook and
Latch Connected
Deck Lock Lever
Deck Secured in TILT-UP Position
DANGER
Do not operate the mower with deck in tilt-
up position. Do not move the tractor with
the deck in the tilt-up position.
CHECK MOWER BLADE CONDITION,
SHARPNESS, BALANCE, AND SECURITY OF
MOUNTING
The blade mounting nuts on gear driven decks should
be torqued to 60 lb·ft (81 N·m), and the blade mount-
ing bolts on belt driven decks torqued to 70 lb·ft
(95 N·m). If blade sharpening is required, refer to
CHECKING/SERVICING
for
Sharpen Mower
Blades
in
Maintenance Instructions.
ADJUST MOWER CUTTING HEIGHT, IF RE-
QUIRED
Position the hitch pins in the four deck support pins.
Refer to the “Cutting Height Adjustment” decal on
the deck gearbox cover.
CHECK SECURITY OF DRIVE WHEEL BOLTS
The eight (8) lug bolts mounting the drive tires should
each be torqued to 75 to 85 lb·ft (102 to 115 N·m).
PERFORM ANY ADDITIONAL PROCEDURES
called for on the
MAINTENANCE SCHEDULE
CHART
in
Maintenance Instructions.
Содержание T25i
Страница 85: ...81 Operator s Notes...
Страница 86: ...82 Operator s Notes...
