Walker B23i, Руководство оператора

Страница: 22 / 76

Assembly Instructions
18
IMPORTANT:
Obtain and use only battery
grade sulfuric acid electrolyte with a 1.265 spe-
cific gravity to activate the battery.
DO NOT
use
water or any other liquid during initial activation.
2. Remove the filler caps and carefully fill each cell
until the electrolyte is just above the plates.
3. After the battery is filled with electrolyte, replace
the filler caps and charge the battery. Refer to
Battery Charging.
Battery Charging
DANGER
BATTERIES PRODUCE EXPLOSIVE GASES
•
Charge the battery in a well-ventilated
area, so that gases produced while charg-
ing can dissipate.
•
Keep sparks, flames, and smoking mate­
rials away from the battery at all times.
•
Make sure the battery cap vents are
open after the battery is filled with acid
(check manifold vent on each cap).
•
Make sure the battery charger is un-
plugged before connecting or disconnect-
ing cables to the battery.
1. Charge the battery at 15 amps for 10 minutes.
DO NOT
exceed 20 amps maximum recom-
mended charging rate. Charge until specific
gravity is at least 1.250. Total charging time
should not exceed one (1) hour.
2. After charging the battery, adjust the electrolyte
level to the bottom of the vent wells [1/4 to 1/2 in.
(6 to 13 mm) above the plates].
IMPORTANT: DO NOT
overfill the battery.
Electrolyte will overflow through the vented caps
onto parts of the machine and
WILL
result in se-
vere corrosion.
3. Install battery.
Battery Installation
IMPORTANT:
Make sure battery is securely mount-
ed in the frame. A loose battery may cause damage
to the case resulting in acid leakage and severe
damage to the machine. A hazard may be created
by damage to critical working parts and safety sys-
tems.
Install the battery in the mower as shown in
Battery
Installation
photo. Connect the positive (+) first and
then the negative (-) cable to the proper battery ter-
minal
[red cable and boot connects to the Posi-
tive (+) terminal].
Slide the rubber boot up and over
the battery post, making sure it covers the post com-
pletely
to prevent an electrical short.
WARNING
Make sure the battery cap vents are open.
Improper venting of the battery COULD
cause a battery explosion.
Battery Clamp
Secured by
Wing Nut(s)
Battery Installation