3
The WR-100 Remote Control Trigger provides an operating range of 100m and even operates
through obstructions (maximum operating range 80m for autofocus function).
The Transmitter has two buttons (Autofocus button and shutter button). When receiving signals, a
LED light lights up additionally. The Receiver has its own shutter button and can be used as cable
release trigger.
The shutter button is operating in two steps:
Step 1: Press the shutter button halfway to focus
Step 2: Press the shutter button fully to take a photo.
1.
Handling
Remove the remote control socket cap of the camera.
2.
Setup
2 model
Slide the function button in the 2 Mode. The receiver is turnoff. Under this condition, the
transmitter can not active the receiver to control the camera. The receiver will not consume
any power of the battery. User can use the shutter button of the receiver to take photos.
Press the shutter button halfway to focus. Press it fully to take a photo.
1 model
Slide the function button in the 1 Mode. The receiver is active. Under this condition, the
receiver can receive the signal from the transmitter; the receiver consumes the power of the
battery. User can uses the Shutter button of the transmitter and Focus button to control the
Camera’s shutter and Focus. Press the transmitter’s shutter button to take a photo. Press the
transmitter’s focus button to focus.
3 model
Slide the function button in the 3 Mode and turn on the camera to BULB mode. Under this
condition, the transmitter opens the lens; Slid the function button in the O Mode, the
transmitter closes the lens. When the camera is under no-Bulb mode and taking the photo,
the transmitter will lock the shutter button, and the camera will implement continues
shooting. Under P mode, the transmitter can not control the receiver.
3.
Operating range
Maximum operating range 100m. (The operating range may be obstructions or interference
with other electronic equipment to reduce the distance)
4.
Charging
The WR-100 inbuilt High Capacity Li-ion battery. Take out the power adapter, plug it into the
power socket of the transmitter and then plug the power adapter to the power outlet. When
the transmitter is under charging, the light of transmitter is on. There are 5 lights, each light
represent 20% of battery power. When all of the lights are on, which mean the battery is full,
please take of the power adapter.
