4
5
6
8
7
9
10
M-C
M-A
M-E
M-E
A
M-E
M-F
M-B
M-D
A
Put the assembled TV/Monitor onto the Arm
B
and ensure stability.
Tighten the VESA plate using Nut
G
and M3x7 Bolt
H
with a screwdriver. (Screwdriver not included)
Adjust the tilt angle using Allen Key 6mm
K
.
Store the Allen Keys in the Tool Holder
F
.
For safety, please do not extend the arms too far forward or backward. This may cause
instability and tip over.
Manually swivel, tilt, and rotate the monitor for the best viewing angle. Adjust the height of VESA
Plate
A
using Allen Key 6mm
K
.
Guide the cable through the Tool Holder
F
and wire clips.
Select M4x12 Bolt
M-A
or M5x12 Bolt
M-C
according to your TV/Monitor, connect
VESA Plate
A
together with D5 Washer
M-E
into the mounting holes on the back of
TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
Select M4x16 Bolt
M-B
or M5x16 Bolt
M-D
according to your TV/Monitor, connect
VESA Plate
A
together with D5 Washer
M-E
and Spacer
M-F
into the mounting
holes on the back of TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
Step 4.1
Select TV Screws
Step 4.2
Select Spacers ( if needed )
Step 4.3a
Step 4.3b
G
H
K
K
K
A
J
F
M4x12
M5x12
Hand thread screws
into the threaded
inserts on the back of
your TV to determine
which screw diameter
(M4x12 or M5x12) to use.
M4x12
M5x12
Hand thread screws
into the threaded
inserts on the back of
your TV to determine
which screw diameter
(M4x12 or M5x12) to use.
Note: Please make sure two arms are aligned and balanced.
Flat Back Monitor
Curved Back Monitor
B
F
0.8” Height Adjustment
