background image

17.6 lbs.

(8 kg)

DVD WALL MOUNT

17.6 lbs.(8 kg) including

CS303

WARNING

●Do not begin the installation of the product before you have read amd understood the

instructions and warnings contained in this installation sheet. if you have any question

regarding any of the instruction or warning, please contact your local distributor

●Please refer to installation guide recommendation for required distance from wall to

avoid risk of property damage.

●This product should only be installed by someone of good mechanical aptitude,with

experience and basic building, and fully understands.
●Make sure that the supporting surface will safely support the combined load of

the equipment and all attached hardware and components.
●If mounting to wood wall studs, make sure that mounting screws are anchored

into the center of the studs. Use of an “edge to edge” stud finder is highly recommended.
●Always use an assistant or mechanical lifting equipment to safely lift and position

equipment.

●Tighten screws firmly, but do not over tingten. Over tightening can damage the

items, greatly reducing their holding power.

●This product intended for indoor use only. Using this product outdoors could

lead to product failure and personal injury.

●Never exceed the maximum load capacity.

IMPORTANT:

Ensure you have received all 

parts against the component 

checklist prior to installing. If 

any parts are missing or faulty, 

call the franchiser for a replacement.

wall plate(x2)

glass shelf(x3)

decorative cover(x4)

glass holder(x3)

connect piece(x3)

D

ST5.5x50(x6)

concrete anchor(x6) M5x14(x9)

plastic bush(x3)

plastic cover(x6)

3mm allen key(x1)

A

B

C

G

E

F

M5x6(x1)

H

Tools required

●Phillips Head Screw driver

(200mm length exclude the handle)

●Electric drill and 8mm masonry bit for 

concrete wall installation

●Marking Pen

●Hammer

STEP 1A WOOD STUD WALL MOUNTING:

●Use a stud finder to locate the edges of the studs. Use of an 

edge-to-edge stud finder is highly recommended.

Based on their edges, draw a vertical line down each 

stud’s center.

●Place wall plate on wall as a template. And mark the 

center of the four mounting holes. Make sure that the  

mounting holes are on the centerline of stud.   

●Drill four 1/8”(3mm) dia. Holes 1.2”(30mm) deep. 

Secure it using four screws(A), make sure that the 

wall plate is level as shown in fig.1.1.

fig.1.1

A

stud

F

H

STEP 1B SOLID BRICK AND CONCRETE BLOCK MOUNTING:

fig.1.2

●Use the wall plate as a template to mark four holes locations 

on the wall.

 

●Pre-drill these holes with a 8mm masonry bit and depth is at l

east 50mm

.  

Insert a Concrete Anchor(B) into each of these holes. Attach the wall plate 

to the wall using four screws(A), make sure that the wall plate is level

 

as 

shown in fig.1.2.

B

A

STEP 2 ASSEMBLING THE GLASS HOLDER

●Attach the connect piece to the glass holder using two screws 

and space reserved

 3mm as shown in fig.2.1

●Use the same method to assemble the other glass holder

fig.2.1

INS

TALL

A

TION MANUAL

[email protected]

B

S

Отзывы: