Waldorf STVC, Руководство пользователя

Страница: 22 / 38

The Control Panel
22 STVC Manual
The Vocoder Section
r
Want to know how a Vocoder works? Please refer to
the corresponding chapter in the Appendix of this
manual.
Vocoder Button
Press this button to activa-
te/deactivate the vocoder. When
active, this button lights up.
r
To hear the Vocoder in effect
you need to talk into a connected
microphone and press at least one
key on the keyboard simultaneous-
ly. Instead of the microphone input
signal you can use a line signal
coming through the pedal input or
a recorded freeze loop (see below).
Microphone XLR connector
Here you can connect the inlcuded
gooseneck microphone or any other
suited microphone.
r
Note that only 2.4 V phantom power is supplied,
microphones requiring 48 V or 12 V are not sup-
ported.
Freeze Button
Press and hold the Freeze button to record the
microphone singal. To specify this, only the filter
coefficients, not the audio signal itself is recorded. The
recorded signal is then played back in a loop. With the
Save function you can save the audio loop, so that it
remains after switching off. Otherwise everything is gone
after switching off the STVC. Keep in mind that only one
audio loop can be saved.
r
The maximum recording capacity depends on the
incoming audio signal and should be about 20
seconds.
r
If you want to use a recorded Freeze signal again,
press both the
Vocoder and the Freeze button.
Otherwise a new recording procedure starts and
overwrites the internal memory.