8
Installation
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
* Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.
Assembly
NOTE:
All Models are delivered completely assembled. No further assembly is required.
This appliance is fitted with adjustable feet to enable appliance to be positioned securely
and level. This should be carried out on completion of gas connection. Refer to ‘Gas
Connection’ section.
Optional Accessories (Refer to Replacement Parts List)
Rear Roller Kit. For installation details, refer to instructions supplied with each kit.
Plinth Kit. For installation details, refer to instructions supplied with each kit.
1.
Check all feet (or castors) are securely fitted.
2.
Adjust feet to make oven range steady and level.
Gas Connection
NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON.
1.
Waldorf Ranges do not require an electrical connection, as they function totally on gas supply only.
2.
It is essential that gas supply is correct for appliance being installed and that adequate supply
pressure and volume are available. The following checks should be made before installation:-
a. Gas Type the appliance has been supplied for is shown
on coloured stickers located above gas connection and
on rating plate. Check that this is correct for the gas
supply the appliance is being installed for. Gas
conversion procedure is shown in this manual.
b. Supply Pressure required for this appliance is shown in
‘Specifications’ section of this manual. Check gas supply
to ensure adequate supply pressure exists.
c. Input Rate of this appliance is shown on Rating Plate
and in ‘Specifications’ section of this manual. Input rate
should be checked against available gas supply line
capacity. Particular note should be taken if
appliance is being added to an existing
installation.
NOTE: It is important that adequately sized piping runs directly to connection joint on appliance
with as few tees and elbows as possible to give maximum supply volume.
3.
Fit gas regulator supplied, into gas supply line as close to appliance as possible.
Combustible Surface
Non Combustible Surface
Left / Right hand side
250 mm (*)
0 mm
Rear
100 mm
0 mm
Fig 1
Rating Plate
Location
This appliance is for professional use and is only to be used by qualified
persons.
Only authorised service persons are to carry out installation, servicing or gas
conversion operations.
Caution