12
Operation
Lighting Pilot Burners
NOTE: All chargrill models incorporate a push button piezo ignition system for each individual
pilot burner.
1.
Depress gas control knob and rotate anti-clockwise to the ‘PILOT’ position.
2.
With gas control knob depressed, press piezo igniter until pilot burner ignites. (Each operation of
the piezo igniter button will generate a single spark). Pilot ignition can be viewed through the
openings in the plastic surround of the piezo igniter button.
3.
Hold in the gas control knob for approximately 10-15 seconds, then release. Pilot burner should
remain alight. (If not repeat Items 2 and 3 above).
Lighting Main Burners
1.
Turn gas controls anti-clockwise to the first stop (‘FULL’ flame position) and allow the chargrill to
heat up to operating temperature.
2.
‘LOW’ flame can be selected by depressing gas control knob and rotating fully anti-clockwise.
3.
For intermediate heat, position gas control knob between ‘HIGH’ and ‘LOW’ positions for the desired
heat setting.
4.
During idle periods, main burners can be turned down to maintain a suitable temperature, or the gas
controls can be set to the ‘PILOT’ position as required.
NOTE:
Always set the gas control knob to the ‘HIGH’ position when lighting main burners.
If pilot burner goes out during normal operation, wait 5 minutes before attempting to
re-light the pilot burner.
W
HEN
A
SOLID
GRIDDLE
PLATE
IS
USED
,
IT
'
S
SURFACE
TEMPERATURE
CAN
REACH
OVER
350°C
WHEN
THE
APPLIANCE
IS
OPERATED
AT
FULL
HEAT
SETTING
.
Warning
IMPORTANT:
Should any abnormal operation occur like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation.
The appliance requires IMMEDIATE service by a qualified service person and should not be
used until a service is carried out.
