500.0030-D
4
Technical alterations reserved
2.2.
Disassembly, interior construction
To correctly anchor the safe (Section 2.3), its complete chrome-steel interior construction
(lid, side walls, base, and rear wall) have to be completely disassembled. It is important to
remove the individual metal plates with care so as to avoid scratching them.
Follow this procedure to disassemble the safe:
CAUTION: CUTTING DANGER ON THE METAL SHEETS!
1.
Open the safe as per the 500.0024 /
500.0026 instruction manual.
2.
Pivot the doors as much as possible
(ideally 180º).
3.
Release the countersunk screw in the lid
(3mm Allen key) and push the clamping
plate backwards. Then, tighten the
countersunk screw again so that the
clamping plate cannot slide forward any
more.
4.
Raise the lid slightly and push it to the
right until the tabs of the lid can be
swivelled past the left-hand side wall.
Once the lid has been swivelled approx.
45º, the tabs can be unhooked on the
right-hand side wall, and the lid can be
pulled out of the safe diagonally.
5.
Completely unscrew the cylinder-head
screw located at the top-centre of the
side wall (4mm Allen key), holding the
side wall in place with your hand to
prevent it from tipping over. Then, allow
the side wall to tilt inwards and pull it out
of the plug connection in the base. As
soon as the side wall is separated from
the base, it can be pulled out of the safe
diagonally.
