Other Useful Information
Monitoring screen
After successful installation you will
see this ‘Monitoring’ screen. It
shows you that your device is
connected. There is no further
action needed on your part.
Set correct time zone
If at any point you need to change
your time zone, you can go to the
device’s ‘Settings’ and do that there.
Give feedback
If you cancel an alarm for whatever
reason, please respond to the
feedback form that automatically
pops up, so we can better serve
you.
Installation Setup and Instructions
To make sure that you are properly
monitored in the event of a fall, it is
important that you follow these steps to
ensure your Walabot HOME device is
correctly installed.
Step 1: Mount the device
on the bathroom wall
Take your Walabot HOME out of the box
and into the bathroom for installation.
Make sure the device’s surface is clean
and dry.
Stick 1 sticker on each of the 4 corners at
the back of the device, within the outlined
section provided:
Make sure the rounded edge of each
sticker is facing outward, and just over
the device’s edge as in the image, to serve
as a pull-tab for easier removal from the
wall, if needed.
12
5