WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE POWER
SOURCE BEFORE ANY ADJUSTMENTS ARE MADE.
WARNING! BE VERY CAREFUL WORKING NEAR THE CUTTERHEAD INSERT TIPS. THEY ARE
EXTREMELY SHARP AND CAN CAUSE INJURY.
LEVELING INFEED AND OUTFEED TABLES
The infeed and outfeed tables must be parallel and level with the planer center wear plate located
under the cutterhead assembly. These have been preset at the factory but may need readjustment.
Using the crank handle, raise the cutterhead assembly to its highest position. Being extremely careful
of the cutterhead insert tips, lay a metal straight edge on the infeed table and center wear plate at both
left and right sides of the table. If the table is not parallel with the wear plate, you can loosen the table
side mounting screws (3 on each side) to get the table parallel and then retighten the screws. Repeat
this procedure for the outfeed table.
（
cont.
）
TABLE MAGNETS
The 2 long table magnets, page 11, should be attached into the holes on the front of the
cutterhead assembly and tightened with the provided nut. See picture on page 4 for reference.
The 2 short table magnets, page 11, are optional. They can be attached into the inner
holes on the rear of the cutterhead assembly only when the dust port is removed.
13
