Page 25
Option B -
Steps for activating a partial factory reset:
1.
While the unit is running and the status LED is steadily lit, press and
hold the reset button.
2.
Continue to hold down the button as the status light first turns off
and then begins to advance through reset options. Every 5 seconds,
the status light will blink to indicate a different reset option as
described below.
1 blink
= Reset type 1
Erases network configuration, reverting back to defaults
for
network configuration only
. All other configuration settings
remain unchanged.
2 blinks
= Reset type 2
Erases all configuration settings, reverting back to factory
defaults. All other system files remain unchanged.
3.
Release the button when you reach the type of reset you need.
4.
The status light will flash rapidly to indicate that the selected settings
have successfully been erased.
5.
Restart your zone controller for the new settings to take effect. You
have successfully reset your configuration!
Note 4:
If you release the button before the LED begins to blink, nothing will be reset, and
you will not need to reboot.
Note 5:
If the status light begins to blink more slowly after you release the button, the reset
was not successful. Unplug and restart your device, and then attempt a reset once again.
