Getting to Know your ELEMNT MINI
The ELEMNT MINI interface consists of the following buttons:
Left button: Use to power on/off and also manage your workout. Hold down for 3
seconds to access the prompt to power down your device.
Right button: Functions as the page toggle to switch between workout data.
Press and release both buttons simultaneously:
o
When not currently performing a workout: to access the Settings Menu
o
During a workout: to start a new lap
Setting Up
This setup guide is intended to assist with configuring your ELEMNT MINI for first use and
pairing to the ELEMNT App and RPM Speed Sensor.
1.
Remove from packaging.
2.
Turn on by pressing either of the two buttons located on the front of the device. After
loading, a QR code will be displayed.
3.
Choose to either pair your ELEMNT MINI to your smartphone or ride in Stand Alone
Mode. Instructions for each section are outlined below.
4.
You MUST pair your RPM Speed Sensor if riding in Stand Alone Mode to get speed and
distance data. See the ‘Add Sensors’ section of this manual for detailed instructions.
NOTE: If you do not see the QR screen on the ELEMNT MINI:
1.
Press and release both buttons simultaneously on the ELEMNT MINI to access settings
2.
Press the Next button (right button)
3.
Press the SELECT button (left button) while on FORGET PHONE.
This will allow the ELEMNT MINI to reboot onto the QR screen
Stand Alone Mode:
In the event that you wish to use your ELEMNT MINI without pairing to a smartphone:
1.
Turn on your ELEMNT MINI by pressing one of the buttons located on the front of the
device.
2.
The ELEMNT MINI will now prompt you to scan the QR code displayed. However, select
Skip to defer scanning the QR code to continue use in standalone mode.
3.
Pair the RPM Speed Sensor included with your ELEMNT MINI. See the ‘Add Sensors’
section of this manual for detailed instructions
