9.
Complete a basic profile to be used with the ELEMNT BOLT. This information will be used to
calculate metrics such as calories and HR zones. Alternatively, select Next and add these later.
10.
Enable Live Track if desired to allow you to see other riders on the ELEMNT BOLT and allows
other ELEMNT users to see you. Additionally, you can also share a link with family and friends
to view your location online.
11.
If you choose to enable Live Track, you can also automatically share your location with others.
Add recipients via email to continue or select Next.
After initial installation, the ELEMNT BOLT will perform a step-by-step tour. Read up on how to
use or select “Skip tour”
to exit. Your ELEMNT BOLT is now set up and ready for action.
Attaching your ELEMNT BOLT to your Bike:
The ELEMNT BOLT comes with two mounts to use, depending on your preference:
•
Aero Out-Front Mount
•
Stem Mount
Choose the mount that best suits your riding style so that you can easily see the screen and access
the buttons safely. Take care when tightening to ensure that the ELEMNT BOLT will be secure
during your ride. For best results, tighten periodically to maintain a secure hold.
INSTALLING THE Aero OUT-FRONT MOUNT:
The Aero Out-Front Mount was designed to be used specifically with the ELEMNT BOLT to gen-
erate the most aerodynamic advantage. The Aero Out-Front Mount consists of a single mount, se-
cured with an allen key bolt (3mm).
NOTE: Allen key not supplied.
1. Begin by removing/loosening the allen key bolt so the Aero Out-Front Mount can slide over one
side of your handlebars.
2. When seated in your preferred location, replace/tighten the allen key bolt until the Aero Out-
Front Mount is securely fastened. The Wahoo logo should be facing upwards (and facing toward
you if you were seated on the bike). Your mount is ready to use.
INSTALLING THE STEM MOUNT:
•
The Stem Mount consists of the following items:
•
4 x zip-ties
•
Plastic Stem Mount
•
Rubber Mount insert
1. Ensure that the Rubber Mount insert is sitting flush with the Plastic Stem Mount. The bike mount
is now ready to be installed.
2. Place the bike mount in alignment on the stem of your bicycle, ensuring that the rubber insert
side is facing down and the Wahoo logo is on top and facing towards you (if you were seated on the
bike). NOTE: This mount can also be installed on your handlebars if required.
3. Thread two of the zip-ties through the holes provided in the bike mount and tighten securely
around the bicycle stem.
4. When tightened to your satisfaction, trim any excess zip-tie cables. Your mount is ready to use.
TO INSTALL THE ELEMNT BOLT ON THE BIKE MOUNT:
