GENERAL
6
TC6XX-TM6XX Series
A.4
Directives CE
A.4.1
Conformity with standards
The device complies with the applicable directives in force on the subject of electrical safety (2006/95/CE) as well as on
the electromagnetic compatibility of the electrical measuring instruments (2004/108/CE).
These instructions for use contain information and warnings which must be observed by the user to protect the latter
against the dangers of electricity, to ensure the safe operation of the device and to protect it against any mishandling
which could damage or compromise the safety of use of the device.
A.4.2
Environmental conditions
In accordance with publication CEI 359: operating category I.
Range of application of standards: from 0 to 2,200 m.
Reference temperature range: 23°C ± 5°C, relative humidity: 45% to 75%.
Nominal operating range: -10°C to +50°C, relative humidity: 20% to 80% non-condensing.
Operating range limit: -15°C to +55°C, relative humidity: 10% to 80% (70% at 55°C).
Storage and transport temperature range limit: - 30°C to + 60°C (without the batteries).
A.4.3
Worn devices
Worn electrical devices can pollute the environment. We recommend you refrain from disposing of this device in an
ordinary waste bin, but rather that you use the recycling circuits available locally.
A.4.3.1
Waste generated by the device
List of waste classified:
16.02.14: Waste originating from electronic equipment:
Printed circuit boards making up the device
16.06.02: Batteries and storage battery (dangerous)
Alkaline batteries
3 V lithium battery (CR1225 type)
Or Ni-MH batteries (If the unit is equipped with an 12436-01 battery pack)
15.01.02: Packaging
ABS plastic and polycarbonate device casing
Elastomer sheath or boot
A.4.3.2
Device destruction procedure
Open the device: unscrew the screw on the battery compartment, followed by the 5 screws securing the 2 shells.
Separate the 2 shells. Separate the PCB from the upper shell.
With regard to the batteries, you will find them in the battery compartment (see commissioning chapter).
In the case of the pack of batteries, there are 2 contaminants: NI-MH (Nickel-Metal Hybrid) batteries and a PCB. Separate
these 2 items.
A.4.4
Instructions
The unit is designed to be used in complete safety if the instructions given in the accompanying documents are followed.
Any use apart from those defined, may prejudice the safety of the operator and is therefore dangerous and forbidden.
