15
Description of Parts
A. Blade set
B.
Cutting length adjustment lever
C. On/off switch
D. Mains cable
E.
Adjusting Screw
F.
Locking switch for cutting length adjustment
G. Attachment comb
H. Blade guard
I.
Cleaning brush
J. Oil for blade set
Not shown: Scissors, grooming comb.
Mains Operation
• Oil the blade (Fig. 6)
• Connect the clipper to the power supply.
• Using the on/off switch, switch on the appliance (Fig. 1a)
• Using the on/off switch, switch off the appliance after every use (Fig. 1b) and
disconnect from the mains.
note
:
An audible click may be heard when switching on the appliance. This is the result of the torque
of the alternating current drive unit. This is normal and not an indication of a fault with the clipper. If a
continuous noise occurs the clipper is not defective but should be readjusted using the adjustment screw
(E) for the available supply voltage (see following section).
Adjusting the blade amplitude (clipper noisy/loud noise)
The blade amplitude is set at the optimum setting at the factory. However, the blade amplitude may
change as a result of voltage fluctuations. For lower voltage the blade amplitude can be smaller and for
higher voltage it may be bigger. If necessary, by changing the setting of the adjusting screw (E), you can
adjust the blade amplitude yourself. You will need a screwdriver to do this.
1.
Using the on/off switch, switch on the appliance (Fig. 1a).
2.
Turn the adjusting screw (E) in a clockwise direction until you hear a loud noise (Fig. 2a).
3.
Then turn the adjusting screw anti-clockwise until the loud noise stops (Fig. 2b)
.
Cutting length adjustment
• Without the attachment comb, the normal cutting length of the clipper blade is approximately
1mm.
•
The cutting length can be adjusted between 1mm and 3mm, even when the clipper is in use.
• Slide down the locking switch (Fig. 3b).
•
By moving the adjustment lever at the side (Fig. 4a) it is possible to set the cutting length at
various pre-set positions (Multi-click).
• Sliding the locking switch upward (Fig. 3a) unlocks the setting and restores the normal cutting
length of approximately 1mm.
Attaching and removing the attachment comb
1. Slide the attachment comb onto the blade set in the direction of the arrow until it reaches the
limit stop (Fig. 5a).
2. The attachment comb can be removed by pushing it in the direction of the arrow (Fig. 5b).
Clipping with the attachment comb in place
Various attachment combs are included with your Starter Kit.
#1 (4.5mm), #2 (6mm), #3 (9mm), #4 (12mm)
Additional attachment combs are available as an accessory at Wahlstore.co.uk.
When using an attachment comb, to achieve the desired cutting lengths, the adjustment lever should not
be locked (Fig. 4b); to achieve this slide the locking switch upward (Fig. 3a).
Model:
Pet
Starter Clipper - WM6406
