16 • Quick Start
The First Program
WAGO-I/O-SYSTEM
750
ETHERNET StarterKit 2
You can change the position of a module in your selection by selecting and
moving the module using the up and down arrow buttons on the right-hand
side of the window.
The 750-600 end module is not shown in the I/O configuration window.
Then confirm your selection with “OK“.
For each I/O module, you can now determine via
Æ
Module parameters if the
outputs of a module will be controlled by the controller (PLC) or by a particu-
lar Ethernet protocol (fieldbus 1 = Modbus/TCP or fieldbus 2 = Ethernet/IP)
(Fig. 14).
Fig. 14: WAGO-I/O-PRO CAA, PLC configuration with 750-400 and -501
In this example, we first used the “PLC“ value.
The I/O configuration window now shows the address of each channel, and
thus each individual bit on the module.
