WAGO-SPEEDWAY 767
Mounting
41
767-5801/000-800 8DIO 24V DC 0.5A IF (8xM8)
Manual
Version 1.1.0
Pos: 21.26 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Beschriftung austauschen 767- xxxx allgemein @ 5\mod_1249034032812_21.docx @ 39780 @ 2 @ 1
4.6
Marking and Replacing the Marking Spaces
The module marker card (10) and marking strip (12) are attached when delivered.
The protective cover is to be removed when labeling the marking strip. To do this,
proceed as follows:
1.
Press the slot screwdriver (maximum slot width: 3mm) into the small
opening under the marking strip cover (12) and lever it up.
2. Remove the marking strip cover.
3. Mark the marking strip with a waterproof pen.
4. Reinsert the marking strip cover and press it firmly in place.
If the module's marker card (10) must be replaced, proceed in accordance with the
step sequence described previously. New module marker cards can be obtained
through WAGO.
Pos: 21.27 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Beschriftung austauschen 767- xxxx_8xM8 - Bil d @ 5\mod_1249280838031_21.docx @ 39793 @ @ 1
Figure 12: Replacing the marking spaces
Pos: 21.28 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
10
12