WAGO-SPEEDWAY 767
Mounting
33
767-4801/000-800 8DO 24V DC 0.5A IF (8xM8)
Manual
Version 1.1.0
Pos: 21.18 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Befestigung auf Tragschi enenadapter 767- xxxx allgemein @ 5\mod_1249030636984_21.docx @ 39754 @ 3 @ 1
4.4.2
Fastening the Module with Carrier Rail Adapter to a Carrier
Rail
In order to provide a clear representation, the carrier rail adapter in the figure
below is shown without module.
When mounting the module to a carrier rail (DIN rail 35 x 7.5) using a carrier rail
adapter, proceed as follows:
1. Disconnect the power supply from those devices on which you wish to
mount the module.
2. Set the module onto the edge of the carrier rail (51) with the two notches
(50).
3. Press the undersurface against the lower carrier rail edge until the latch (52)
locks in place.
Use end stops
When mounting the rail vertically or if shock or vibration loading should occur,
the use of end stops (item no.: 249-116 or 249-117) for stabilization is required.
Pos: 21.19 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Befestigung auf Tragschi enenadapter 767- xxxx - Bil d @ 5\mod_1249030807718_21.docx @ 39757 @ @ 1
Figure 10: Mounting the carrier rail adapter (exemplary)
Pos: 21.20 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
50
51
52
