WAGO 751-5201, Руководство пользователя

Страница: 11 / 20

751-5201 [AS-Interface Module 4IN/4OUT 24V/2A Single] • 11
Display Elements
WAGO-I/O-SYSTEM 751
AS-Interface Components IP67
2.1.1.4 Display Elements
Tab. 2.1.1-2: Display Elements
LED Designation Status Function
off Input 1, Signal voltage (0)
IN 1
yellow
Status
DI1
on Input 1, Signal voltage (1)
off Input 2, Signal voltage (0)
IN 2
yellow
Status
DI2
on Input 2, Signal voltage (1)
off Input 3, Signal voltage (0)
IN 3
yellow
Status
DI3
on Input 3, Signal voltage (1)
off Input 4, Signal voltage (0)
IN 4
yellow
Status
DI4
on Input 4, Signal voltage (1)
off Output 1, reset
OUT 1
yellow
Status
DO1
on Output 1, set
off Output 2, reset
OUT 2
yellow
Status
DO2
on Output 2, set
off Output 3, reset
OUT 3
yellow
Status
DO3
on Output 3, set
off Output 4, reset
OUT 4
yellow
Status
DO4
on Output 4, set
off OK
on Configuration error
FID/
FAULT
red
Error
blinking
Short circuit / sensor
supply overload or actuator
supply is missing or output
driver error message
(Open-Load-Detection)
off Actuator supply error
AUX
green
Actuator
supply
on Actuator supply OK
off AS-Interface supply error
IN 3 IN 4
IN 1 IN 2
OUT 3
OUT 1
OUT 4
OUT 2
FID/FAULT
ASI AUX
IR
Fig. 2.1.1-4: Display
Elements
gq52012x
ASI
green
AS-Interface
supply
on AS-Interface supply OK
2.1.1.5 Operating Elements
Above the programming connector is an infrared sensor for communication
with a programming device with optical interface. Please note manufacturer
documentation for the operation of the programming device.