WAGO 4PS, Руководство пользователя

Страница: 3 / 41

Wag - 4PU & 4PS - 3
1 Safety instructions
Information for your own safety
This manual does not contain all of the safety measures for operation of this meter because special operating
conditions, local code requirements or local regulations may necessitate further measures. However, it does
contain information which must be adhered to for your own personal safety and to avoid material damage. This
information is highlighted by a warning triangle with an exclamation mark or a lightning bolt depending on the
degree of actual or potential danger:
Warning
This means that failure to observe the instruction can result in death, serious injury or
considerable material damage.
Caution
This means hazard of electric shock and failure to take the necessary safety precautions will
result in death, serious injury or considerable material damage.
Qualified personnel
Installation and operation of the device described in this manual may only be performed by qualified
personnel. Only people that are authorized to install, connect and use this device, who have the proper
knowledge about labeling and grounding electrical equipment and circuits and can do so in accordance with
local (safety)regulations, are considered qualified personnel in this manual.
Use for the intended perpose
This device may only be used for the application cases specified in the catalog and the user manual and
only in connection with devices and components recommended and approved by Wago.
Proper handling
The prerequisites for perfect, reliable operation of the product are proper transport, storage, installation and
connection, as well as proper operation and maintenance. During its operation certain parts of the meter might
carry dangerous voltages.
•
Only use insulated tools suitable for the voltages this meter is used for.
•
Do not connect while the circuit is connected to a power or current source.
•
Only place the meter in a dry environment.
•
The meter is intended to be installed in a Mechanical Environment ‘M1’, with Shock and Vibrations of low
significan- ce and Electromagnetic Environment ‘E2’, as per 2014/32/EC Directive. The meter is intended
for indoor use. The meter shall be installed inside a suitable IP rated enclosure, in accordance with local
codes and regulations.
•
Do not mount the meter in an explosive area or exposed to dust, mildew and/or insects.
•
Make sure the used wires are suitable for the maximum current of this meter.
•
Make sure the AC wires are connected correctly before activating the current/voltage to the meter.