WAGO 2789-9080, Руководство по эксплуатации продукта

Страница: 18 / 40

2789-9080 Fieldbus Description
18 | Version: 1.1.0
Communication Module IO-Link
4.2.2 Specific Module Parameters of the WAGO Power Supply Pro 2
The product uses the following WAGO-specific parameters:
Table 15: WAGO-specific parameters
Index Subindex Parameters Data Type Data length
(Bytes) Description
12001 0 Part number
module StringT 8 Module item
number
12002 0 Part number ex-
tension (module) StringT 8 Item number ex-
tension of the
module
12003 0 Hardware version
module StringT 2 HW Release In-
dex of the mod-
ule in the "XX"
format
12004 0 Firmware version
module StringT 8 FW Revision of
the module in the
"XX.XX.XX" for-
mat
12005 0 Configuration ID
module UIntegerT 4 Configuration ID
of the module
4.2.3 Data Structure for WAGO Power Supplies Pro 2
The product has the following structure:
• 5-byte input process data
• 1-byte output process data
The structure of the input and output process data is explained below.
Input Process Data
The product has the following input process data (5 bytes):
Table 16: Process Data Structure
Byte Description
0 Status messages (see Table “Status Message Structure”)
1 … 2 Measured output current 0.000 … 65.535 A in steps of 1 mA
3 … 4 Measured output voltage 0.000 … 65.535 V insteps of 1 mV
Table 17: Status Message Structure
Bit Description
0 DC OK
Set when the output voltage is OK.
1 Overtemperature shutdown T ≥ T
max
2 No output voltage
3 Short circuit at output
4 Digital output set
5 … 7 Reserved
Output Process Data
The product has the following output process data (1 byte):