GB
6
Large spray attachment
General instruction
Read the operating instructions carefully beforeusing the tool and observe the safety
instructions. Keep the operating instructions in a safe place.
The
Large spray attachment
was developed for applying water-soluble paints and
lacquers as well as paints and lacquers containing solvents.
CAUTION!
•
The units may only be used with a functional valve.
If paints rises in the
ventilating hose (Fig. 1 A, item 12) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from different spray attachments.
The parts could be damaged.
Description (Fig. 1)
1) Gun body
2) Needle
3) Nozzle seal
4) Nozzle
5) Air cap
6) Union nut
7) Material quantity regulation
8) Trigger
9) Container seal
10) Feed tube
11) Container
12) Ventilating hose
13) Valve cover
14) Diaphragm
15) O-ring
Preparation of the Coating Material
The Large spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer (
Internet download).
1.
Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes
undiluted
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents
undiluted
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-film glazes
dilute by 5 - 10%
(undiluted with Flexio)
2.
If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
