WAGNER WallPerfect W 687 E I-Spray, Руководство пользователя

Страница: 37 / 86

GB
29
W 687 E I-Spray
The spray movement should come from the arm, not just from the wrist. This ensures that
•
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm.
fig. 12 A/ 12 B: COrreCt Even distance to the object.
fig. 12 B: inCOrreCt
An uneven distance will result in uneven paint
application.
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
•
pattern setting.
An even movement of the spray gun results in an even surface quality.
•
When coating material builds up on the nozzle and air cap, clean both parts with a
•
solvent or water.
i
"Cross spray" when using paint with a poor covering capacity or if the
surface is highly absorbent (Fig. 13).
i
Interior wall paint in strong colour shades should be applied at least twice
(allow first paint coat to dry first). This will ensure good coverage.
16. interruption of Work till 4 Hours
Turn the machine off.
•
During longer breaks, vent the container by briefly opening and then closing it again.
•
Clean nozzle openings after an interruption in operation.
•
When processing 2-component varnishes, clean the device immediately.
•
17. taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application
device. no warranty claims are accepted in case of improper or no cleaning.
Turn the machine off. Vent the container in case of longer breaks and after the work 1)
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
Divide the spray gun. Press the hook (Fig. 5 "click") slightly downwards. Turn the gun 2)
front part and gun rear part against each other and take them apart.
Unscrew the container. Empty any remaining coating material back into the material 3)
tin.
Preclean the container and feed tube with a brush. Clean the ventilating bore 4)
(Fig. 14, A).
Pour solvent or water into the container. Screw the container back on. 5)
Do not use flammable materials for cleaning purposes.