GB
Vector Pro
21
i
Lubricate all packings and moving parts before reassembly with a
lithium-based grease.
9. Install the seal assembly into the front of the gun head.
10.Replace the retractor plate (4) inside the rear of the gun head. Make sure
the flats just above the threads on the seal assembly are horizontal so it
slides through the hole in the retractor plate.
11.Using a 3/8” socket, tighten the lock nut onto the end of the seal assembly.
Torque to 5 Nm (3.7 ft. - lbs.).
12.With the trigger depressed, install the diffuser into the front of the gun head
and tighten securely with a wrench.
13.Replace the rear housing.
rePlAciNG/remoViNG the Filter
i
The gun filter should be cleaned after every use.
1. Unclip the top of the trigger guard from the gun head.
2. Using the bottom of the trigger guard as a wrench, loosen and remove the
handle assembly from the gun head.
3. Pull the old filter out of the gun head. Clean or replace.
4. Slide the new filter, tapered end first, into the gun head.
5. Thread the handle assembly into the gun head. Tighten with the trigger
wrench.
6. Snap the trigger guard back onto the gun head.
Filter chArt
Part
Number
Application
Filter
type
Filter
color
0034383
Synthetic resin, enamels, clean
varnishes, stains, azures
Extra-fine Red
0043235
Base coat enamels, primer
enamels, fillers, marking paints,
textured enamels
Fine
Yellow
0034377
Emulsions, latex paints, acrylic
paints
Medium
White
0089323
Filler paints, large area surfaces
Coarse
Green
Uncontrolled Copy