WAGNER GA 5000EAC, Руководство по эксплуатации

Страница: 40 / 88

Operating manual GA 5000EAC Electrostatic Automatic Spray Gun (AirCoat)
7 Operation
40 Order number 2360922 | Edition 09/2022
Spray pattern and air regulation
For the IC variant, the air regulation regulates the ratio of shaping/atomizing air. For the IC
variant, the shaping and atomizing air are set individually. The spray pattern can then be
adjusted to optimally suit the object being sprayed. The illustration shows the influence of
the regulator on the spray pattern. Other nozzle sizes can be used to obtain larger or smaller
spray patterns.
+ -
B_05762
1 2
1 Air regulation fully opened = maxi-
mum shaping air 2 Air regulation closed = minimum shap-
ing air
Changing the flow rate
1. Adapt product pressure.
2. Use a different nozzle (see chapter Accessories [ 8 69]).
Changing the Spray Jet Width
4
Use a different nozzle (see chapter Accessories [
8
69]).
7.4 SPRAYING
1. Secure spray gun (switch off controller) and insert the desired nozzle.
2. Turn on the control unit. See corresponding operating manual.
3. Start up with product pressure generator set to approx. 8 MPa; 80 bar; 1160 psi
operating pressure. See corresponding operating manual.
AirLess spraying
1. Turn both air pressure regulators at the control unit all the way down.
2. Spray on a test object (switch on the controller).
3. Adjust the product pressure and gun air in accordance with the nozzle and object.
AirCoat spraying
1. For the IC variant, open the air pressure regulator (approx. 0.05 - 0.25 MPa; 0.5 - 2.5 bar;
7 - 36 psi) and adjust for optimal atomization.
2. For the EC variant, set shaping and atomizing air on the pressure regulators.