WAGNER 2389341, Руководство пользователя

Страница: 26 / 60

20
Studio Home Decor Sprayer GB
9. Adjusting the desired Spray Setting
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 4, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 5 A
= vertical flat jet

for horizontal surfaces
Fig. 5 B = horizontal flat jet

for vertical surfaces
Fig. 5 C
= circular jet

for corners, edges and hard-to-reach surfaces
10. Adjusting the Material Volume (Fig. 6)
Adjust the material volume by rotating the regulator on the back of the gun. There is a
scale on the regulator for guidance (I to IIII).
+ turn to the left
 higher material volume
- turn to the right
 lower material volume
11. Spray Technique
•
The spray result depends heavily on the smoothness and cleanliness of the surface to
be sprayed. Therefore the surface should be carefully prepared and kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
•
It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important: Begin spraying outside of the target area and avoid interruptions inside
the target area.
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 5 - 15 cm, depending on the desired
spray jet width.
Fig. 7 a: CORRECT Even distance to the object.
Fig. 7 b: INCORRECT Uneven distance causes uneven coating.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
•
When coating material builds up on the nozzle and air cap, clean both parts with a
solvent or water.
i
For inspiration and useful tips, visit