EN
G
LIS
H
9
User’s Manual—Read before using this equipment
Brief Recap of Sequences for Connection and Disconnection
2
3
1
ORDER OF CONNECTION
2. Connect positive (red)
clamp to positive battery
terminal.
1. Connect cables to iOnBoost.
3. Connect negative (black)
clamp to solid metal ground
on engine or frame, away
from battery).
1
2
3
ORDER OF DISCONNECTION
2.
Disconnect positive
(red) clamp from positive
battery terminal.
1.
Disconnect negative
(black) clamp
from frame.
3.
Disconnect cables from
iOnBoost.
READ THE REMAINDER OF THE INSTRUCTIONS BEFORE USING THE IONBOOST!
Jumpstart Procedure
1. Turn off the vehicle ignition and all accessories (radios, lights, air conditioners), and disconnect
electronic devices.
2. Set the emergency brake and put vehicles with automatic transmission in park position.
3. Determine the polarity of the vehicle’s battery terminals. The positive (POS, P, +) battery
terminal usually is red and larger in diameter than the negative (NEG, N, −) terminal. If you
are unsure, first refer to the vehicle owner’s manual. Make sure the negative battery terminal is
also connected to the vehicle frame.
4. If engine was recently cranked, use a non conductive material (cardboard or a folded
newspaper) to wave away (dispel) explosive gases. Do this for a few minutes before any
vehicle connections.
5. Insert the blue plug of the jumper cables into the iOnBoost’s jumper terminal. When fully
inserted, the red and green lights on the cable safety block should both flash continuously.
Never allow clamps (positive & negative terminals) to touch together or contact the same
piece of metal to prevent short-circuits and arcing�
6. Securely connect the positive (+) red clamp to the positive (POS, P, +) terminal of the vehicle
battery or the remote positive (+) terminal if equipped.
7. Securely connect the negative (−) black clamp to a non-moving, metal part of the engine or
frame as far away from the vehicle battery as possible.
