www.wagan.com
13
Elite 1000W—Pure Sine Inverter
by Wagan Tech
©2009 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
14
User’s Manual—Read before using this equipment
Attach the positive cable to the Positive (+) DC connector on the battery
and then the inverter. Make sure the connections are tight and secure.
Turn ON the inverter from the Front Panel On/OFF Switch
Make certain that the green Operating LED is lit and the FAULT LED
indicator is not lit.
Turn OFF (0) the inverter. The Fault LED may briefly “flash”. This is
normal. The audible alarm may also sound a short “chirp”. This is
also normal.
When you have confirmed that the appliance to be operated is turned
off, plug the appliance into one of the two AC outlets on the front panel
of the inverter.
Turn the inverter on.
Check operation of the Remote Switch – Press “Lock” to turn Off
the inverter.
Press the Unlock button to turn On the inverter.
Turn the appliance on. The appliance should begin working.
Observe the LED indicators and the Digital Display for Normal
operation.
Note: If an extension cord is used from the inverter to the appliance, limit the
extension cord length to 100 feet or less. Make sure that the cord is safety
approved and AWG 14 or greater to carry the appliance load. Remember
that extension cords are for temporary use.
Charging the Battery Bank
It is not the purpose of this inverter user’s guide to provide detailed information
regarding battery charging systems. However, the user should try to augment
any stationary inverter charging system with either wind power or solar
power. These can continue to operate during power outages and they also
reduce recharge time. For mobile or marine charging systems, a higher rated
alternator may be necessary to charge a battery bank.
8.
9.
10.
11.
12.
13.
14.
15.
16.
1.
Regular Loss of Commercial Power
If the inverter system is used during commercial power outages that occur
daily, configure the charger system to replace energy during the time that
commercial power is available.
Replacement of battery energy always requires more than was taken from
the battery (typically 30 percent more). Follow battery manufacturer’s
recommendations for maximum charging current.
Warning:
T
here
is
danger
of
explosion
. do noT
connecT
or
disconnecT
charger
cables
direcTly
afTer
baTTery
discharge
or
recharge
–
make
sure
ThaT
The
baTTery
bank
area
is
Well
venTed
before
aTTaching
or
removing
cables
.
If the flooded lead acid batteries are used, be sure that periodic checks of
battery electrolyte levels are accomplished. Follow battery manufacturer’s
instructions in keeping the electrolytes at the proper level. Be sure to use pure
distilled water when replacing evaporated electrolyte liquid.
Operating Issues
(Television and Audio Equipment Suggestions.)
Although all inverters are shielded and filtered to minimize signal interference,
some interference with your television picture may be unavoidable, especially
with weak signals. However, here are some suggestions that may improve
reception.
Make sure that the television antenna produces a clear signal under
normal operating conditions (i.e. at home plugged into a standard
110/120V AC wall outlet). Also ensure that the antenna cable is properly
shielded and of good quality.
Sometimes vehicle alternators produce some electrical noise. There are
filters available to mount on the alternator to reduce noise.
Change the positions of the inverter, antenna cables and television
power cord.
•
•
•
Содержание Elite 1000W
Страница 1: ...item 2203 User s Manual SHEMO080100244TXC ...
